Operation Manual

POWX0280 EN
Copyright © 2018 VARO P a g e | 6 www.varo.com
For masonry, such as brick, cinder block, cemetery, etc, use carbide tipped drill bits.
Use enough pressure to keep the bit biting but do not push so hard that do not stall the
motor or damage the bit.
Always apply pressure in a straight line with the bit.
Hold the drill firmly to control the twisting of the drill.
WarningIf the drill stalls, release the trigger immediately, remove the drill
from the work and determine the cause of the stalling. Do not click the switch
on and off as this can damage the motor.
To minimize the chance of stalling and breaking through the material, reduce the pressure
on the drill and ease the bit through the last part of the hole.
Keep the motor running when pulling the bit back out of a drilled hole. This will help
prevent jamming.
8 MAINTENANCE
Do not attempt to make any adjustments while the tool is in operation.
Clean out any accumulated dust with a brush or dry cloth.
Do not allow petroleum-based products to come into contact with plastic parts as they contain
chemicals, which could damage, weaken or destroy plastic.
9 TECHNICAL DATA
Mains voltage
Power input
No load speed
Chuck capacity
Double isolation
Impact rate
Max. drill capacity
Wood
Steel
Concrete
10 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
95 dB(A)
Acoustic power level LwA
106 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration)
9 m/s²
K = 1,5 m/s²
11 WARRANTY
This product is warranted for a 36-month period effective from the date of purchase by the
first user.
This warranty covers all material or production flaws excluding : batteries, chargers,
defective parts subject to normal wear & tear such as bearings, brushes, cables, and
plugs, or accessories such as drills, drill bits, saw blades, etc. ; damage or defects
resulting from maltreatment, accidents or alterations; nor the cost of transportation.