Operation Manual

POWX0330 EN
Copyright © 2017 VARO P a g e | 4 www.varo.com
 Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and
gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in
moving parts.
 If devices are provided for the connection of dust extraction and collection facilities, ensure
these are connected and properly used. Use of these devices can reduce dust related
hazards.
5.4 Power tool use and care
 Do not force the power tool. Use the correct power tool for your application. The correct
power tool will do the job better and safer at the rate for which it was designed.
 Do not use the power tool if the switch does not turn it on and off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
 Disconnect the plug from the power source before making any adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
 Store idle power tools out of the reach of children and do not allow persons unfamiliar with
the power tool or these instructions to operate the power tool. Power tools are dangerous
in the hands of untrained users.
 Maintain power tools. Check for misalignment or sticking of moving parts, breakage of
parts and any other condition that may affect the power tool’s operation. If damaged, have
the power tool repaired before use. Many accidents are caused by poorly maintained
power tools.
 Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to stick and are easier to control.
 Use the power tool, accessories and tool bits etc., in accordance with these instructions
and in the manner intended for the particular type of power tool, taking into account the
working conditions and the work to be performed. Use of the power tool for operations
different from intended could lead to a hazardous situation.
5.5 Service
 Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
6 OPERATING INSTRUCTIONS
6.1 Starting up (Fig. 1)
6.1.1 Instant response operation
Switching on: Press the On/Off switch.
Switching off: Release the On/Off switch
6.1.2 Continuous operation
Switching on: Press the On/0ff switch, keep pressed and lock with the locking button Switching
off: Press the On/Off switch and release
6.1.3 Electronic speed control setting
By turning the speed regulator forward or backward, you can get the variable speed.
Turn the speed regulator to a higher number for a higher speed and turn it to a lower number
for a lower speed. The ideal cutting rate depends on the specific material and working
conditions.
The general rules for tool speed in cutting operations apply
6.2 Changing the saw blade (Fig. 2)
Push the lever of blade clamp upwards as the arrow shows on the Fig. 2 and slide the saw
blade into the locating groove with teeth pointing forward. Make sure that the back edge of the
blade fits into the blade clamp and then release the lever of blade clamp.