Operation Manual

POWX0360 EN
Copyright © 2017 VARO P a g e | 6 www.varo.com
7.6 Transfer switch for wind direction (Fig. 5)
Slide the transfer switch forward to change the wind direction forward as the arrow shows on
the above Fig. 9 that avoid sawdust cover previously marked line on the work-piece which it’s
convenient for moving the tool forward along previously marked line.
7.7 Use of pendulum
Position
Cutting action
Applications
0
Straight line cutting action
For cutting mild steel, stainless steel and plastics.
For clean cuts in wood and plywood.
I
Small orbit cutting action
For cutting mild steel, aluminum and hard wood.
II
Medium orbit cutting action
For cutting wood and plywood.
For fast cutting in aluminum and mild steel.
III
Large orbit cutting action
For fast cutting in wood and plywood.
8 TECHNICAL DATA
Nominal voltage
230-240V-50Hz
Power consumption
810 W
Cutting rate
800-3000 strokes/min
Cutting depth in wood
80 mm
Cutting depth in steel
10 mm
Mitre cuts
up to 45' (left and right)
Double isolation
Yes
Weight
3,8 kg
9 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
94 dB(A)
Acoustic power level LwA
105 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration)
Max 11,9 m/s²
K = 1,5 m/s²