User Manual

POW1044 EN
Copyright © 2013 VARO P a g e | 7 www.varo.com
7.4 Mounting the parallel fence
The parallel fence allows sawing parallel to an edge at a
maximum distance of 10 cm.
 Loosen the lock know of edge guide.
 Slide the edge guide through the slots in the shoe to the
desired width.
 Tighten the lock bolt to secure it in the position.
 Ensure that the edge guide rests against the wood along its
entire length to give a consistent parallel cuts.
8 OPERATION
8.1 Instructions for use
 Clamp the workpiece. Make sure that the side which will be visible later is facing down,
because the cut is most accurate at that side.
 Switch on the machine before it touches the workpiece. Do not exert pressure on the saw
blade. Allow the machine enough time to cut the workpiece.
 Hold the machine with both hands using both grips. This ensures optimum control over the
machine.
 For straight cuts along a drawn line use the marking for straight cuts .
 For bevel cuts along a drawn line use the marking for bevel cuts.
8.2 Switching on and off
 To switch the tool on, keep the lock-off button (13) depressed and press the on/off switch
(12).
 To switch the tool off, release the on/off switch.
8.3 Dust extraction
A vacuum cleaner can be connected to the dust extraction connector, either directly to the
connector or using an adapter.
 If necessary, connect an adapter to the connector (1).
 Preferably use a vacuum cleaner for industrial use.