User Manual

POWX067 EN

9.2 Flange arrangement when using a depressed-centre cutting wheel

9.3 Flange arrangement when using a straight cutting wheel

10 CLEANING AND MAINTENANCE

Attention! Before performing any work on the equipment, pull the power

plug.

10.1 Cleaning

§ Keep the ventilation slots of the machine clean to prevent overheating of the engine.

§ Regularly clean the machine housing with a soft cloth, preferably after each use.

§ Keep the ventilation slots free from dust and dirt.

§ If the dirt does not come off use a soft cloth moistened with soapy water.

Never use solvents such as petrol, alcohol, ammonia water, etc. These

solvents may damage the plastic parts.

10.2 Lubrication

The machine does not require any specific lubrication.

10.3 Replacing Coal Brushes

Remove and check the carbon brushes regularly. Replace when they have worn down to the

limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon

brushes must be replaced at the same time. Only use original carbon brushes.