Operation Manual

POWX07573T EN
Copyright © 2016 VARO P a g e | 10 www.varo.com
 Switch on the power tool.
 Move the handle (15) slowly downwards. You have to push the safety switch (17) before
you can do this.
 For long workpieces you should use the slide; loosen the locking knob for this purpose.
 Saw trough the work piece.
 Switch off the power tool.
 Wait until the saw blade (2) has come to a complete standstill before removing the work
piece.
9.13 Sawing special work pieces
Curved or round work pieces need to be secured against slipping.
Make sure there is no gap between the work piece and the fence (4) or the saw table (5).
9.14 Replacing the saw blade (Fig. 4)
Disconnect the tool from the outlet before working on the saw blade.
Wait a while before touching the saw blade. It can be very hot.
The teeth of the saw blade are very sharp.
 Remove the two screws and turn the plastic covers upwards, so that you can see the
attachment bolt of the saw blade.
 Push in the blocking knob, position the supplied key on the bolt and loosen the bolt in a
clockwise direction.
 Pull the mitre saw downwards and lock it in the lowest position by pushing the retaining
pin.
 Remove the front mounting screw from the protective hood
 Turn the centre cover and raise the blade guard.
 Press the spindle lock.
 Then remove the screw, outer flange and blade.
 Replace the saw blade (the tips of the sawing teeth have to point in the same direction as
indicated by the arrow on the cover) and then resassemble all parts in the reverse order.
 Turn the plastic cover back in its original position and mount the front mounting screw from
the protective hood.
When replacing the saw blade, you can tighten the slide bar with the
locking knob (23).
10 CLEANING AND MAINTENANCE
Before performing any work on the equipment, pull the power plug.
10.1 Cleaning
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 If the dirt does not come off use a soft cloth moistened with soapy water.
 Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Make sure no water can reach the inside of the power tool!