User Manual

POWX0761 EN

6.3 When using in the table saw (bench saw) mode:

 Do not perform any operation freehand. Freehand means using your hands to support or

guide the workpiece, in lieu of (6) rip fence.

 Make sure that the turn table is fixed securely.

 Make sure that the arm is securely fixed in the working position. Tighten the lever clockwise

to fix the arm.

 Use (6) push stick or (6) push block to avoid working with the hands and fingers close to the

saw blade.

 Make sure the blade is not contacting the riving knife or workpiece before the switch is

turned on.

 Always store the push-stick when it is not in use.

 Pay particular attention to instructions for reducing risk of KICKBACK. KICKBACK is (6)

sudden reaction to (6) pinched, bound or misaligned saw blade. KICKBACK causes the

ejection of the workpiece from the tool back towards the operator. KICKBACKS CAN LEAD

TO SERIOUS PERSONAL INJURY. Avoid KICKBACKS by keeping the blade sharp, by

keeping the rip fence parallel to the blade, by keeping the riving knife and blade guard in

place and operating properly, by not releasing the workpiece until you have pushed it all the

way past the blade, and by not ripping (6) workpiece that is twisted or warped or does not

have (6) straight edge to guide along the fence.

 Avoid abrupt, fast feeding. Feed as slowly as possible when cutting hard workpieces. Do

not bend or twist workpiece while feeding. If you stall or jam the blade in the workpiece, turn

the tool off immediately. Unplug the tool. Then clear the jam.

 Before turning over the tool, always make sure that the stopper pin has securely locked the

tool head in the lowest position.

7 INSTALLATION

CAUTION: Keep the floor area around the tool level, well maintained and

free of loose materials e.g. chips and cut-offs.

7.1 Bench mounting (Fig. 1 & 3)

7.1.1 For the fully-extended feet set up as the high table.

When the tool cannot be set up stable, turn the adjusting nut at the foot of the tool for proper

stability. Turn counterclockwise in top viewing to make the foot shorter and clockwise in top

viewing to make it longer. After adjustment, make sure that the tool keep stable.

7.1.2 For the folded feet set up as the low table

When the tool is ready in the foot-folded position, secure the tool by using U-shaped grooves

shown in the figure. (fig 3 (5) )