Operation Manual

POWX0761 EN
Copyright © 2008 VARO P a g e | 2 www.varo.com
9.2 Table height two-way set up ............................................................................... 12
9.2.1 High table set up (Fig. 18) ...................................................................................... 12
9.2.2 Low table set up (Fig. 19) ...................................................................................... 13
9.3 Installing or removing saw blade ........................................................................ 13
9.4 Adjusting riving knife (fig 25,26 & 27) ................................................................ 13
9.5 Installing and adjusting rip fence (Fig. 28) ......................................................... 14
9.6 Installing and adjusting Mitre gauge (Fig. 35) .................................................... 15
9.7 Dust bag (Fig 36, 37 & 38) ................................................................................... 15
9.8 Securing workpiece ............................................................................................. 15
9.9 Setting up the tool in table saw mode ................................................................ 15
9.9.1 Securing the turn table (Fig. 41) ............................................................................. 15
9.9.2 Securing the tool head (Fig. 42) ............................................................................. 16
9.9.3 Releasing the lower limit stopper (Fig. 43) ............................................................. 16
9.9.4 Repositioning the riving knife (Fig. 44) ................................................................... 16
9.9.5 Removing the lower blade guard (Fig. 45) ............................................................. 16
9.9.6 Locking the tool head at fully lowered position (Fig. 46) ......................................... 16
9.9.7 Turning over the tool (Fig. 48) ................................................................................ 16
9.9.8 Installing the top blade guard (Fig. 49) ................................................................... 16
9.10 Setting up the tool in Mitre saw mode (Fig. 50) ................................................. 17
9.10.1 Removing the top blade guard ............................................................................... 17
9.10.2 Installing the lower blade guard C .......................................................................... 17
9.10.3 Turning over the tool .............................................................................................. 17
9.10.4 Releasing the tool head from fully lowered position ................................................ 17
9.10.5 Repositioning riving knife (Fig. 51) ......................................................................... 17
9.10.6 Installing or removing the sub fences R and L (Fig. 52) .......................................... 17
10 OPERATION.................................................................................. 18
10.1 Cutting as mitre saw ............................................................................................ 18
10.1.1 Press cutting .......................................................................................................... 18
10.1.2 Mitre cutting ........................................................................................................... 18
10.1.3 Bevel cut ................................................................................................................ 18
10.1.4 Compound cutting .................................................................................................. 19
10.1.5 Cutting aluminum extrusion (Fig. 56)...................................................................... 19