Technical data

POWX093 EN

7.3 Dust extraction outlet

You are advised to use the dust extraction outlet. You can purchase

a suitable commercial vacuum cleaner or extract the dust via an

extractor tube while the cutting machine is in operation. The outlet

must project out of the rear of the machine (5). Two bolts and nuts

are supplied to attach it.

Hold the extractor outlet in position and lay the cutting machine on its side. Push the long bolt

through the machine base until it projects at the fastening point for the extractor outlet (6).

Place the nut in the hexagon-shaped recess (7). Tighten the bolt with a suitable wrench and

moderate force until the outlet is securely attached. Repeat the procedure at the other side.

CAUTION: Dust may cause respiratory problems. Certain laminated board

materials are carcinogenic. After work, always remove all dust from the

machine.

7.4 Assembly of parallel stop

Locate the parallel stop and the guide rods. Push the guide rods into the casting and secure

them with the adjusting screws (8). Inspect the machine base and the four securing points.

Loosen the locking screws and push the guide rods into the machine base (9). The parallel

stop is continuously adjustable and permits various parallel cuts.