Operation Manual

POWX1025 EN

8.6 Stationary use

This tool can also be used in stationary mode.

▪ Place the tool onto the workbench.

▪ Secure the cable to prevent pulling the tool off the workbench.

▪ Carefully switch the tool on.

Make sure that the nozzle always points away from you and any

bystanders.

Make sure not to drop anything into the nozzle.

8.7 Mounting the correct accessory

Icon

Description

Purpose

Glass protection nozzle

Protecting windows when stripping frames

Spoon reflector nozzle

Soldering pipes

Cone nozzle

Welding, shrink sleeving (heat

concentrated over small area)

Fish tail surface nozzle

Drying, thawing (heat spread over wider

area)

Scraper

Stripping paint and varnish

Make sure that the tool is switched off and the nozzle has cooled down.

Set the desired accessory onto the nozzle.

8.8 Cooling down (Fig. B)

The nozzle and accessory become very hot during use. Let them cool down before attempting

to move or store the tool.

Place this hot air gun vertically during cooling time or rest after operation.

▪ To reduce the cooling time, switch the tool on at position ‘I’ and let in run for a few

minutes.

▪ Switch the tool off and let it cool down for at least 30 minutes.

9 MAINTENANCE AND CLEANING

Attention !Before performing any work on the equipment, pull the power

plug.