Technical data

POWX1160 EN
Copyright © 2015 VARO NV P a g e | 7 www.varo.com
Important! When hammer drilling you will require a low pressure. Too much
pressure will place unnecessary load on the motor. Check the drill bits
regularly. Re-sharpen or replace blunt drill bits.
Always wait until the machine has come to a complete standstill before
changing the drilling, hammer/drilling function.
9 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
9.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
9.2 Replacing Coal Brushes
Remove and check the carbon brushes regurarly. Replace when they have worn down to the
limit mark.
Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes must be
replaced at the same time. Only use original carbon brushes.
10 TECHNICAL DATA
Rated Voltage
220-240 V
Rated Frequency
50 Hz
Rated Power
1500 W
Rotation speed
850 min
-1
Protection class
II
Drill capacity concrete
32 mm
Drill capacity steel
16 mm
Drill capacity wood
40 mm
Impact rate
4100 min
-1
Cable length
3 m + VDE plug
11 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
95 dB(A)
Acoustic power level LwA
106 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration)
17,7 m/s²
K = 1,5 m/s²