Operation Manual

POWX1170 EN
Copyright © 2016 VARO P a g e | 5 www.varo.com
 Always disconnect the hammer drill from the electric supply before you change a chisel or
drill bit.
 Protect your eyes and other workers from flying particles and splinters. Wear a helmet! Set
up partition walls!
 Wear work gloves to protect fingers from bruising and grazing.
 Vibrations can injure the hand-arm system. Keep exposure to vibrations as short as
possible.
 Always lead the mains cable away backwards from the device.
 Store the device where it is inaccessible to children.
 When carrying out work, always hold the device with both hands and ensure that you have
a stable standing position.
7 BEFORE STARTING WORK
 Examine the place where the device is to be used for hidden electrical cables, gas and
water pipes using a pipe finding device.
 Before connecting to the mains, ensure care that the mains voltage corresponds to the
details on the rating plate.
7.1 Fitting and changing tools (Fig. 1)
The device is equipped with a SDS- plus attachment system.
 Clean tools and grease with a thin layer of machine grease before fitting.
For assembly:
 Pull back fastening sleeve (A) and hold.
 Push and rotate the dust-free tool into the tool holder as far as it will go. The tool will lock
automatically.
 Check that it has locked by pulling the tool.
Removing SDS-plus tool
 Pull back fastening sleeve (A), hold and remove tool.
Accessories can be hot after use. Don’t touch the tip of accerroty by hand!
Always use protective gloves to remove the accessory!
7.2 Mounting/Dismount the auxiliary 13mm chuck for drilling in steel, wood and
plastic (Fig. 2)
Mount:
 Pull back and hold the locking sleeve A of the SDS chuck.
 Clean the adapter shank and put a bit of grease on it.
 Push the auxiliary chuck into the SDS chuck.
 Turn slowly to the right.
 Release the locking sleeve A.
Dismount:
 Pull back fastening sleeve (A), hold and remove tool.
7.3 Depth guide (Fig. 3)
Your drilling depth can be pre-set and/or repeated by using the depth stop.
Insert the required drill bit. Fit the depth stop into the hole of auxiliary handle and set the
required depth
7.4 Dust cover (Fig. 4)
Slide the dust cover device over the drill bit before carrying out any hammer drilling vertically
above your head.