Operation Manual

POWX1170 EN

7.5 Fitting the auxiliary handle (Fig. 5)

The auxiliary handle can be fitted to suit both right-handed and left-handed users.

Always use the tool with the auxiliary handle properly assembly .

Loosen the auxiliary handle by unscrewing it.

For right handed users, slide the auxiliary handle clamp over the collar behind the bit holder,

handle at the left.

For left handed users, Slide the auxiliary handle clamp over the collar behind the bit holder,

handle at the right.

Rotate the side handle to the desire position and tighten the handle.

7.6 Selecting the operation mode (Fig. 6)

The rotary hammer drill can be used in the following operation modes.

 Rotary drilling

For screwdriver and for drilling into steel, wood and plastics.

 Hammer drilling

Simultaneous rotating and impacting for concrete and masonry drilling

 Hammer only

for light chipping, chiselling and demolition applications .

 Bit rotation

Non-working position used only to rotate a flat chisel into the desire position.

Select the required operating mode by depressing the safety button and rotating the mode

selector switch until it points to the symbol of the required mode.

Release the safety button and check that the mode selector switch is locked place.

Do not select the operating mode when the tool is running.

For screw driving, refer to section: “Instructions for use”.

Always wait until the machine has come to a complete standstill before

changing the drilling , hammer/drilling function.

Do not use the chuck with SDS connector in combination with the

hammer/hammer drill function!

8 OPERATION

Important! When hammer drilling you will require a low pressure. Too much

pressure will place unnecessary load on the motor. Check the drill bits

regularly. Resharpen or replace blunt drill bits.

8.1 Switch on/off (Fig. 6)

Plug the cord set into power socket.