Phau Ntawv Qhia

POWX11861 EN

▪ To prevent the oil from running out in an uncontrolled manner, hold a small metal chute

under the opening and collect the oil in a vessel until it has fully drained out of the

machine.

Important: The waste oil must be disposed of in the appropriate

collection point for waste oil.

▪ Add new oil (approx. 25 ml) through the oil filler opening until the oil level reaches the

required level. Tighten the hexagonal screw again.

▪ Re-check the oil level after a short period of operation.

10 MAINTENANCE

Check every day the tightening of screws and nuts. Except the procedures described in this

manual, this tool needs no specific maintenance. The repair of the tool's inner components is

of the competence of specialists. The cleaning of plastic parts is done with a soft damp cloth

and a bit of mild soap. Never submerge the tool and do not use detergents, alcohol, spirit,

etc...For an in-depth cleaning, please consult the after-sales department.

WARNING: For maintenance and cleaning, always remove the plug from

the electric power supply. Never use water or other liquids to clean

electric parts.

11 TECHNICAL DATA

Rated voltage – rated frequency

220-230V~ 50Hz

Rated Power

1700W

Protection class

class II

Cable length

Chuck type

SDS Hex

Impact Rate

1900 beats/min

12 NOISE

Noise emission values measured according to relevant standard. (K=3)

Acoustic pressure level LpA

84 dB(A)

Acoustic power level LwA

105 dB(A)

ATTENTION! Wear hearing protection when sound pressure is over 85

dB(A).

aw (Vibration):

17.8 m/s²

K = 1.5 m/s²

13 SERVICE DEPARTMENT

▪ Damaged switches must be replaced by our after-sales service department.

▪ If the connecting cable (or mains plug) is damaged, it must be replaced by a particular

connecting cable which is available from our service department. Replacement of the

connecting cable must only be carried out by our service department (see last page) or by

a qualified person (qualified electrician).