Operation Manual

POWX01250 EN

 The supply cable is intended for normal conditions of use. It is designed to resist normal

mechanical stresses. Do not make loops in the cable or put objects which might damage it

on top of it. Also make sure that the cable does not come into contact with any liquid or

any source of heat and that it is not used in a damp environment. Do not withdraw the plug

from the socket by pulling on the cable.

 Before any maintenance operation, manipulation or any intervention on the machine (such

as assembly, disassembly, adjustment, etc), always disconnect the power supply plug and

wait until the machine has come to a standstill.

 It is compulsory to wear certified gloves and protective goggles when using the device.

 Never use the machine without its protective guard and “spark guards”.

 Always check that the work supports are firmly fixed before using the machine.

 As the wheel wears down, adjust the work support and screen slide:

 1.5mm between the work support and the wheel

 2mm between the slide and the wheel

 When using the grinder, stand in a stable, balanced position, without stretching, and keep

children at a distance.

 Never leave the machine running unsupervised. Keep the workshop clean and tidy.

 Before use, make sure the grinding wheels are not damaged or cracked. If there is the

slightest doubt, replace at once (a damaged grinding wheel can fly apart at speed).

 Replacement grinding wheels must be identical in characteristics and dimensions.

 This machine is not suitable for grinding soft substances such as lead, magnesium or light

alloys.

7 OPERATION

7.1 Assembly instructions

Before use, the eye shields/spark arresters must be fitted to the grinder. Remove both eye

shields from packaging, position the shields over the two mounting brackets above the

grinding wheels with the flanges of the spark arrester facing away from you, fix with the screw

and washer provided. At this stage do not fully Tighten.

7.2 Work rest adjustment

Take the work rest out of the package, fix on the grinder with the knob and washer provided

as shown in dia3. The gap between the rests and the wheels should be checked before use.

Measure the gap between the grinding wheel and the rests; this should be as small as

possible not greater than 2 mm, if not, loosen the two knobs on each of the rests, set the

correct gap and fully tighten. The gap must be maintained as the wheel wears.

7.3 Operating

Make sure grinder is securely mounted; mounting holes are provided in the base of the grinder

for this purpose, but the screws are not provided. Plug in the mains supply and push the on/off

switch right to the on position. Switch off and unplug the grinder when not in use.

7.4 Changing grinding wheels

To change the grinding wheels, first unplug from mains supply then remove the eye shield

brackets, then undo and remove the three screws holding the wheel guard covers in place.

Remove the cover. Undo and remove the two wheels retaining nuts (a). You may have to hold

the wheel and give the spanner a firm tap with a soft headed hammer to release the nut, take

off the large domed washer(b), paper washer(c) and remove the wheels(d).