Operation Manual

POWX1335LI EN

 Never attempt to charge non-rechargeable batteries.

 Have defective cords replaced immediately.

 Do not expose to water.

 Do not open the charger.

 Do not probe the charger.

 The charger is intended for indoor use only.

8 ASSEMBLY

8.1 Battery charging

Use only the battery charger supplied with your tool. Only these battery chargers are matched

to the lithium ion battery of your power tool.

Note: The battery is supplied partially charged. To ensure full capacity of

the battery, completely charge the battery in the battery charger before

using your power tool for the first time. The lithium ion battery can be

charged at any time without reducing its service life. Interrupting the

charging procedure does not damage the battery.

8.2 Charging indication

The charger has two LED light (red and green). The green one is the power indicator.

When the charger is plugged in, this will light up.

When properly connected, the green and red light is lit continuously, this means the battery is

charging.

When the battery is fully loaded, the green light is continuously lit and the red light is out.

If the green and red light flash alternating, a malfunction occurs.

8.3 To install or remove the battery pack

8.3.1 To remove the battery

Depress both the battery release buttons and gently pull the battery out of the tool.

8.3.2 To install the battery

Hold the tool upright in one hand and the battery in your other hand. While pressing with two

fingers on the battery release buttons, insert the battery until it clicks into place. Do not use

excessive force when inserting the battery. If the battery does not slide in easily, it is not being

inserted correctly. It is also possible that there could be damage to the battery, battery

terminals or the tool.

8.4 Changing the accessory

Before any work on the machine itself (e.g. maintenance, accessory

change, etc.) as well as during transport and storage, remove the battery

from the power tool. There is danger of injury when unintentionally

actuating the On/Off switch.

Wear protective gloves when changing application tools/accessories.

Contact with the application tool/accessoriy can lead to injuries.

8.4.1 Selecting the Application Tool/Accessory

Accessory

Material