Operation Manual

POWX1335LI EN
Copyright © 2014 VARO P a g e | 8 www.varo.com
Plunge saw blade (10)
Wooden materials, plastic,
gypsum and other soft materials.
Segment saw blade(12)
Wooden materials, plastic, non-
ferrous metals.
Stainless steel scraper (11)
Wood, paint, carpet adhesive,
silicone and other elastic
materials.
Sanding plate (8)
Depends on sanding sheet (9)
8.4.2 Mounting/Replacing the Application Tool/ Accessory
 If required, remove an already mounted application tool/accessory.
 For removing the application tool/accessory, loosen the screw with the hex key and
remove the application tool/accessory.
 Mount the requested application tool/accessory in such a manner on the tool holder that
the offset faces downward.
 Turn the application tool/accessory to a position favourable for the respective job, and
allow it to engage into the cams of the tool holder.
 Fasten the application tool/accessory with the flange screw. Tighten the flange screw with
hex key until the flange screw faces flush against the application tool/accessory.
Check the tight seating of the application tool/accessory. Incorrect or not
securely fastened application tools/accessories can come loose during
operation and pose a hazard.
8.4.3 Mounting/Replacing a Sanding Sheet on the Sanding Plate
 The sanding plate is fitted with Hook & loop backing for quick and easy fastening of
sanding sheets with Hook & loop adhesion.
 Before attaching the sanding sheet, free the Hook & loop backing of the sanding plate
from any debris by tapping against it in order to enable optimum adhesion.
 Position the sanding sheet flush alongside one edge of the sanding plate, then lay the
sanding sheet onto the sanding plate and press firmly.
 To remove the sanding sheet, grasp it at one of the tips and pull it off from the sanding
plate.
9 OPERATION
9.1 Switching ON/OFF
Make sure the fully charged battery pack is installed.
 Switch the power tool on: push the ON/OFF switch button forwards to the “ON” position.
 Switch the power tool off: pull the ON/OFF switch button backwards to the “OFF” position.
9.2 Adjusting the frequency
Adjust the frequency according to the application before beginning with the work. For example,
we recommend a high frequency for work with the scraper. Conduct a test run in order to find
a suitable frequency.
The frequency controller can be set at 6 positions. The “1”position indicates the lowest
frequency and the“6”position indicates the highest. The operator may have to vary the speed
to optimize cutting efficiency.
9.3 Working Advice