Operation Manual

POWX1335LI EN
Copyright © 2014 VARO P a g e | 9 www.varo.com
9.3.1 Sawing
Use undamaged faultless saw blades only. Deformed, blunt saw blades or
saw blades that are otherwise damaged can break.
Plunge cuts may only be applied to soft materials, such as wood, gypsum
plaster boards, etc.!
Before sawing with saw blades in wood, particle board, building materials, etc., check these
for foreign objects such as nails, screws, or similar. If required, remove foreign objects or use
saw blades for metal.
9.3.2 Separating
Note: When separating wall tiles take into consideration that the application tools/accessories
wear heavily when used for longer periods of time.
9.3.3 Sanding
The removal rate and the sanding pattern are primarily determined by the choice of sanding
sheet, the preset oscillation rate and the applied pressure.
Only flawless sanding sheets achieve good sanding capacity and extend the service life of the
machine.
Pay attention to apply uniform sanding pressure; this increases the working life of the sanding
sheets.
Intensifying the sanding pressure does not lead to an increase of the sanding capacity, but to
increased wear of the machine and the sanding sheet.
For precise on-the-spot sanding of edges, corners and hard to reach areas, it is also possible
to work only with the tip or an edge of the sanding plate.
When selectively sanding on the spot, the sanding sheet can heat up considerably. Reduce
the orbital stroke rate and allow the sanding sheet to cool down regularly.
A sanding sheet that has been used for metal should not be used for other materials.
9.3.4 Scraping
For scraping, select a high oscillation rate.
Work on a soft surface (e.g. wood) at a flat angle and apply only light pressure. Otherwise the
scraper can cut into the surface.
10 MAINTENANCE
10.1 General
Your tool has been designed to operate over a long period of time with a minimum of
maintenance.
 Continuous satisfactory operation depends upon proper tool care and regular cleaning.
Clean your tool using a damp cloth.
 Your charger does not require any maintenance apart from regular cleaning, unplug it
before cleaning.
 Use a soft brush or dry cloth.
 KEEP VENTILATION SLOTS CLEAN! Periodically check the air vents for dust or other
debris. Clean with compressed air (max. 3 bar)
Do not use any abrasive or solvent-based cleaner. Use clean cloths to remove dirt, carbon
dust, etc.