Operation Manual

POWX1341 EN

7.3 Attaching small tools directly to the multitool.

- Turn the collet chuck grip slightly while holding down the locking button

until the button engages.

Never press down on the locking button while the tool is running.

If the collet chuck grip cannot be loosened by hand, use the small spanner.

- Change the attachment tool. Always tighten attachment tools as much as possible. Shafts

which extend out from the collet will cause wobbling.

- Tighten the collet chuck grip. To replace the collet chuck, remove the collet chuck grip and

replace the chuck.

7.4 Accessories

7.4.1 Grinding bits

▪ Use: sharpening, deburring, rust

removal, shaping.

▪ Tip: Clean and shape the grinding bits

with the honing stone.

7.4.2 Grinding points

▪ Use: For fine engraving of various materials.

▪ Tip: Work on metals at a low speed and process

as if it were hardwood.

▪ Plastics must be processed at low speeds

because of their tendency to melt during

processing.

▪ Operating multi tool at a higher speed will

lessen vibration.

7.4.3 Sander

▪ Use: sanding , smoothing and shaping wood

and fiberglass.

7.4.4 Grinding stone

▪ Use: Cleaning and shaping grinding stones