User Manual

POWX323 EN
Copyright © 2013 VARO P a g e | 6 www.varo.com
6 SPECIFIC SAFETY WARNINGS
 Do not vacuum up highly inflammable liquids, acids or thinners.
 Do not vacuum up water at a temperature above 60 °C.
 Do not vacuum up toxic substances.
 Never vacuum up dry waste material or dust without filter in place.
 Check whether the dust filter has been removed when using the machine far vacuuming
up liquids.
 If you use an extension cord, it must be of a watertight construction.
7 ASSEMBLY
7.1 Mounting the swivel castors
 Remove the motor housing (3).
 Turn the tub (6) upside down and insert the swivel castors (8) in the openings creating an
imaginary square while placing them.
 Turn the tub upright again.
 Re-fit the motor housing.
7.2 Mounting the hose
 Insert the hose (9) in the connection (7) and turn to lock.
7.3 Fitting the advanced filter ( FIG B)
The advanced filter is suitable for collecting small waste material and dust.
 Remove the motor housing (3).
 Place the advanced filter at the underside of the motorhousing.
 Turn to lock filter.
 Re-fit the motor housing.
7.4 Fitting a dust bag
A dust bag is suitable for collecting small waste material and dust.
 Remove the motor housing (3).
 Place a dust bag on the connection (7). Make sure to slide the opening past the raised
edge.
 Re-fit the motor housing.
7.5 Fitting and removing the motor housing
The motor housing has been locked to the tub with clamps.
 To remove the motor housing (3). first remove the clamps (5) and then lift it from the tub
(6).
 To re-fit the motor housing, place it on the tub and tighten the clamps.
7.6 Mounting the tube to the hose
 Slide the tube on the handgrip.
 Place the required nozzle on the tail end of the tube.
7.7 POWX323 - Connecting an electrical tool ( FIG C)
The machine has been equipped with an electronic outlet for connection of your electrical
equipment. The machine is switched on automatically the moment you switch on the electrical
tool.
 Connect the hose (9) directly to the dust extraction outlet of the electrical tool.
 Insert the mains plug of the electrical tool into the outlet (2).