Operation Manual

POWX351 EN
Copyright © 2017 VARO P a g e | 10 www.varo.com
11.3 Over painting
 Spray gun not clean. or not lubricated, resulting in piston being stuck in cylinder
Disassemble spray gun and clean with thinner.
 Too much paint
Adjust the volume clockwise to reduce spraying. Two thin coats are better than one thick coat.
 Viscosity too low
Check viscosity
11.4 Motor louder than normal
 Spray gun not clean. or not lubricated, resulting in piston being stuck in cylinder
Disassemble spray gun and clean with thinner.
11.5 No spray no sound
 No electricity
Check power supply.
11.6 Operating sound not right
 Poor output adjustment
Re-adjust
 Not enough paint in the container resulting in air being sucked in air being sucked in.
Refill with paint.
 Not diluting properly or not passing pick up pipe completely.
Check pick up pipe and viscosity level.
11.7 “Orange Skin" excessive fogging
 Incorrect solvent is used
Use correct solvent
 Spray gun to far from the surface.
Hold spray gun closer to the object
 Paint too thick
Thin the pain