Operation Manual

POWX354 EN
Copyright © 2016 VARO P a g e | 5 www.varo.com
 THINNING - Always read the paint manufacturers thinning recommendations or
instructions before using paint or other materials.
 DISCONNECT FROM THE MAINS SUPPLY - Always disconnect from the mains supply
when filling the paint container or cleaning the spray gun.
 SWITCH OFF WHEN NOT SPRAYING – Avoid running the unit with the flow rate knob
fully closed for any length of time.
We accept no responsibility for damage caused by the use of unsuitable
substances, or paints that have not been thinned correctly, and any health
hazards that arise from lack of adequate ventilation.
5.1 Immediately switch off the spray gun when:
 Interruption in the mains plug, mains lead or mains lead damage.
 Defect switch.
 Smoke or stench of scorched isolation.
5.2 Coating materials suitable for use
Water- and solvent-based paints, finishes, primers, 2-component paints, clear finishes,
automotive finishes, staining sealers and wood sealer-preservatives.
5.3 Coating materials not suitable for use
Wall paints (emulsion paints) etc., alkali and acidic paints. Coating materials with a flash point
below 21 °C.
5.4 Preparation of the coating material
The enclosed spray attachment can be used to spray paints, varnishes and glazes that are
undiluted or slightly diluted.
 Stir the material up and put the required amount into the paint container.
Thinning recommendation
Sprayed material
Glazes
undiluted
Wood preservatives, mordants, oils, disinfection
agents, plant protective agents
undiluted
Paints containing solvents and water-soluble
paints, primers, vehicle coating paints,
hick-flm glazes
dilute by 5 - 10%
 If the convey capacity is too low, add 5 - 10% dilution step-by-step until the convey
capacity fulfils your requirements.
6 START-UP
Before connecting to the mains supply, be sure that the supply voltage is identical with the
value given on the rating plate.
 Unscrew the container from the spray gun.
 Aligning suction tube (Fig. 2).
If the suction tube is positioned correctly, the container contents can be sprayed without
almost any residue.
When working on lying objects: Turn the suction tube forwards (Fig. 2 A).
Spraying work when working on overhead objects: Turn the suction tube rearwards (Fig. 2 B).
 Set the container on a sheet of paper, pour in the prepared coating material and screw the
container tightly onto the spray gun.
 Put the machine down only on a level, clean surface. Otherwise the machine could tip
over!
 Adjust the spray setting on the spray gun.