Operation Manual

POWX373LI EN

8 ASSEMBLY

1. Place the suction head with the rubber wiper blades on the device until you hear it lock in.

2. Ensure the dirty water reservoir is securely locked into position before use.

9 OPERATION

9.1 Charging the battery

1. Plug the charger into the socket on the main unit an then plug into the mains to charge.

During charging the red LED will illuminate. Once the battery is fully

charged the LED will turn green.

2. Recharge the battery after use.

9.2 Cleaning

1. Apply the detergent to loosen the dirt.

2. Switch the appliance on. The charge/operating operating light should light up.

3. Maneuver the appliance from top to bottom or sideways to vacuum up the detergent.

4. After use, switch off and stand on a flat surface

Note: Switch the appliance off after each cleaned surface. This will increase

your operating time per battery charge. If the battery is losing power,

recharge the battery.

9.3 Emptying the tank

Once the maximum capacity level of the removable recovery tank is reached, please empty

the tank.

1. Turn off the appliance.

2. Pull off the removable recovery tank and empty it.

3. Place the tank back.

10 CLEANING AND MAINTENANCE

1. Turn off the appliance.

2. Remove the suction head with the rubber wiper blades from the device.

3. Clean the suction head with rubber wiper blades under running water. Do not wash in

dishwasher.

CAUTION: The basic appliance contains electrical components. Do not

clean this under running water.

4. Remove the tank

5. Empty the tank and rinse with clear water. Close the tank.

6. Let the cleaned appliance dry.

CAUTION: Store the appliance in a dry room.