Operation Manual

POWXG1006 EN
Copyright © 2015 VARO P a g e | 12 www.varo.com
12 CLEANING AND MAINTENANCE
Always pull the plug out of the power socket before doing any work on the
chainsaw!
 Keep the cooling vents on the motor housing clean and unobstructed at all times.
 Only the maintenance work described in these operating instructions may be carried out.
Any other maintenance work must be carried out by our Customer Service.
 Do not modify the power saw in any way as this could jeopardize its safety.
 Should the chainsaw fail despite our careful manufacturing and inspection procedures,
have it repaired by an authorized Customer Service work-shop.
13 TROUBLESHOOTING
FAULT
CAUSE
REMEDY
Motor does not
run
No electricity
Check socket, cable and plug .
Damaged cable: Have repaired by Customer
Service. It is prohibited to patch the cable with
insulating tape .
Damaged switches have to be replaced by a
Customer Service workshop.
Chain brake
See section “chain brake“ and “Releasing the
chain brake“
Running out of
carbon brush
Change the carbon brush, ask a Customer
Service workshop
Chain does not
move
Chain brake
Check the chain brake, release if necessary.
Poor cutting
performance
Blunt chain
Sharpen the chain
Chain tension
Chain wrongly fitted
Check that the chain
is fitted correctly
Check the chain tension
Saw works only
with difficulty
Chain tension
Check the chain tension
Chain jumps off
sword
Chain becomes
hot
Chain lubrication
Check oil level
Check Chain lubrication
14 TECHNICAL DATA
Type
POWXG1006
Rated voltage/frequency
230-240V~ 50Hz
Rated power
2400W
Bar length
16” (405mm)
No load chain speed
15m/s
Chain brake time
0.12 s
Tank capacity of lubricating oil
170 ml
Protection class
II
Weight
5.0 kg