User Manual

POWXG7201 EN
Copyright © 2015 VARO P a g e | 11 www.varo.com
13 TROUBLE SHOOTING
Problem
Possible causes
Remedy
Motor does
not start
No electricity
Check mains connection
Defective cable
Check cable, plug in, replace if required, or have
it repaired by a qualified person
Defective safety
switch/plug combination
Arrange for repair in a specialist workshop
Overheat protection
actived
1. Working depth too large, set to the shorter
depth
2. Blades blocked, remover the blockage
3. Soil too hard, select correct work depth and
forwards and backwards several times while
slowly down the operation speed.
4. Wait till the motor cool down for around 15
minutes before rework
Abnormal
noises
Blade is jammed
Switch off wait till complete stop. Remove the
objects
Lubrication running out
Arrange for repair in a specialist workshop
Loose bolts, nuts or other
securing components
Tighten all components, contact specialist
workshop if noises prevail
Abnormal
vibrations
Blades damaged or worn
Replace or have it checked by an specialist
workshop
Working depth too large
Set to correct working depth
Poor
scarification
results
Working depth too small
Set to correct working depth
Worn blades
Replace or have it checked by an specialist
workshop
14 TECHNICAL DATA
Power supply voltage:
230V~ 50Hz
Power consumption:
1200W
Idle Speed:
350 min
-1
Working width:
400 mm
Working depth max.:
200 mm
15 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
72 dB(A)
Acoustic power level LwA
93 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration)
2.6 m/s²
K = 1,5 m/s²