Submittal Sheet

LEAD FREE
*
Product Specification
Job Name
–––––––––––––––––––––––––––––––––––––––––––
Contractor
––––––––––––––––––––––––––––––––––––––––––––
Job Location
–––––––––––––––––––––––––––––––––––––––––
Approval
–––––––––––––––––––––––––––––––––––––––––––––
Engineer
–––––––––––––––––––––––––––––––––––––––––––––
Contractor’s P.O. No.
––––––––––––––––––––––––––––––––––
Approval
–––––––––––––––––––––––––––––––––––––––––––––
Representative
––––––––––––––––––––––––––––––––––––––––
Powers product specifications in U.S. customary units and metric are approximate and are provided for reference only. For precise measurements,
please contact Powers Technical Service. Powers reserves the right to change or modify product design, construction, specifications, or materials with-
out prior notice and without incurring any obligation to make such changes and modifications on Powers products previously or subsequently sold.
ES-P-LFe480_LFG480
Series LFe480 and
LFG480
Lavatory Tempering Valve
Features
• Adjustable temperature selection with locknut to
prevent tampering
• Advanced thermal actuator improves performance
• Temperature controls to ASSE 1070, down to 0.5 gpm for
LFe480 & 0.25 gpm for LFG480
• Lead Free* brass body for durability & to comply with Lead
Free* installation requirements
• Corrosion resistant internal components for extended life
• Integral checks with screens prevents cross flow and filter
out debris
• Factory set to 105°F (41°C)
Specifications
Connections See ordering code
Maximum Operating Pressure 125 psi (861 kPa)
Maximum Hot Water Temperature 180°F (82°C)
Minimum Hot Water Supply Temperature 5°F (3°C) above
set point+
Hot Water Inlet Temperature Range 120 – 180°F (49 – 82°C)
Cold Water Inlet Temperature Range 40 – 80°F (4 – 27°C)
Temperature Adjustment Range 80 – 120°F (27 – 49°C)
Minimum Flow
LFe480 0.5 gpm (1.9 lpm)
LFG480 0.25 gpm (1.0 lpm)
Listing ASSE 1070, IAPMO
cUPC, NSF61-G
Approval CSA B125.3
Flow Capacity
* The wetted surface of this product contacted by consumable water con-
tains less than 0.25% of lead by weight.
+ With Equal Pressure
Advanced Thermal
Actuation
LFe480-00
LFe480-10
LFe480-50
PSI
G
P
M
0 10 20 30 40 50 60 70 80 90 100
7
6
5
4
3
2
1
0
LFE480
LFG480
The information contained herein is not intended to replace the
full product installation and safety information available or the
experience of a trained product installer. You are required to
thoroughly read all installation instructions and product safety
information before beginning the installation of this product.
NOTICE