User Guide

47
Scheduled Testing, Inspection and Maintenance
Testing/Inspection
WARNING
!
Need for Periodic Inspection/Maintenance: This product must be
tested periodically in compliance with local codes, but at least once per year
or more as service conditions warrant. All products must be retested once
maintenance has been performed. Corrosive water conditions and/or unauthor-
ized adjustments or repair could render the product ineffective for the service
intended. Regular checking and cleaning of the product’s internal and external
components helps assure maximum life and proper product function.
Maintenance
■ Actuator and/or Valve Removal
■ Actuator Removal Instructions
Valves and actuators are not field serviceable. They must be removed and replaced.
NOTICE
BEFORE attempting to open Control
Module, a certified and qualified elec-
trician MUST fully de-energize and
disconnect all electrical power from
IntelliStation
®
.
Perform required LOCK OUT/TAG OUT
procedures.
When done, reconnection and reenergiz
-
ing of IntelliStation
®
MUST be performed
by certified and qualified electrician.
DANGER
!
Tools Required:
• 10mm and 3/8" sockets, elbow and torque wrench. Not required if replacing both valve and actuator
• T30 Torx driver. Not required if replacing both valve and actuator
• 2.5mm Allen key. Not required if replacing both valve and actuator
• 1/8" (3.2mm, #2) slot screwdriver. Not required for valve only replacement
• Wire Stripper and snips. Not required for valve only replacement
• AC Voltmeter. Not required for valve only replacement
• Five to ten 4" zap straps (cable ties)
• 4" & 6" monkey wrenches (gas grips)
• 3" adjustable wrenches (shifting spanner)
• Teflon Tape. Not required for actuator only replacement