User Guide

Installation

Failure to follow all installation requirements risks possible death, personal injury,

property damage, and failure of the IntelliStation

Jr. LFIS075VL, LFIS100VL,

LFIS150VL and LFIS200VL to perform as intended.

• Installation of these valves MUST be performed by qualiﬁed technicians, including licensed electricians

and plumbers, following all manufacturer’s instructions, complying with all local, state, federal and other

governmental requirements, and with all building and construction codes and standards.

• Use ONLY with a potable water distribution system free of debris, foreign materials, corrosive chemicals

or substances, and other adverse conditions.

• LFIS075VL, LFIS100VL, LFIS150VL and LFIS200VL are recommended for use as part of an ASSE

compliant water distribution system, including mixing valves and/or temperature limiting devices at all

point-of-use ﬁxtures (faucets, sinks, tubs, showers, etc.).

• LFIS075VL, LFIS100VL, LFIS150VL and LFIS200VL MUST be installed indoor in a dry enclosed area not

susceptible to the weather elements such as rain, snow, ice, freezing temperature, direct sunlight or

excessive heat.

• Keep work area clean, well-lighted, free of clutter and distractions, and accessible only by authorized

personnel and workers.

• LFIS075VL, LFIS100VL, LFIS150VL and LFIS200VL valves and touchscreen display must be located in

accessible and well lighted area for use, servicing, repair or replacement by authorized personnel.

• Valves Control Module is electrically powered. ALWAYS take proper precautions to recognize, evaluate,

and control electricity hazards during installation, programming, use and service/maintenance.

WARNING

NOTICE

Installation of IntelliStation

Jr. is performed by the owner using qualiﬁed and licensed trades such as

plumbers and electricians, following all local, state, federal and other governmental requirements, and all

building and construction codes and standards. Step-by-step installation instructions depend upon the

application and the conﬁguration of the building’s water distribution system.

All installations require thorough ﬂushing of all piping BEFORE installation, and testing for and eliminating all

leaks before and after installation.

Radio Frequency Interference

The installer must ensure that this control and its wiring are isolated and/or shielded from strong sources of

electromagnetic noise. Conversely, this Class B digital apparatus complies with Part 15 of the FCC Rules and

meets all requirements of the North American Interference-Causing Equipment Regulations. However, if this

control does cause harmful interference to radio or television reception, which is determined by turning the

control off and on, the user is encouraged to try to correct the interference by re-orientating or relocating

the receiving antenna, relocating the receiver with respect to this control, and/or connecting the control to a

different circuit from that to which the receiver is connected.