Full Product Manual

1. Position the middle frame (B) with the arrow on the

"UP" decal pointing UP when viewed from rear.

Align the middle frame mount holes to the holes on

the lower frame (A).

Note: If middle frame (B) is installed upside-down,

the chute crank rod eye-bolt will not line up when

installing the chute crank rod.

Decal viewed from rear.

8x 28x3

M8x50

2. Insert the handle saddle screw (AA) with the metal

washer (BB) into the aligned holes on each side. The

metal washer (BB) should be inserted outside of the

frame.

Note: Avoid damaging screw threads during installation.

Handle Saddle Screw

3.Use the handle camlocks (CC) to secure the connection.

The handle camlocks (CC) should be inserted outside of

the frame. Tighten the camlock just snug to the handle.

NOTICE: To avoid breaking the camlock, Do Not overtighten

the camlock. The camlock tightens as it is pivoted when

clamped. If the camlock is initially threaded too tight and then

clamped, it will break. Only slight clamping pressure is

required to hold the handle in place.

Handle Camlock