Instructions / Assembly

13
ASSEMBLY AND ADJUSTMENTS
The following section describes steps necessary to prepare the snow thrower for use. If after reading this
section, you are unsure about how to perform any of the steps please call [phone] Mon-Fri 9-5
EST for customer service. Failure to perform these steps properly can damage the snow thrower or
shorten its life.
Unpacking
Unpack the snow thrower and all its parts, and compare against the list below.
1. Snow Thrower
2. Discharge Chute Assembly
3. Lower Handle
4. One Pair of Skid Shoes with hardware
5. 4 Extra Shear Pins and Locknuts
ASSEMBLY
Your Snow Thrower will require some assembly. Please complete the following steps before using your
Snow Thrower.
WARNING: This snow thrower is heavy. Assembly procedures may require lifting
equipment or two people.
Step 1 – Handle assembly
1. Attach the lower handle using four (4) bolts. Each side will require
two (2) bolts.
2. Attached the upper handle to the lower handle using (4) knobs,
washers and bolts.
Bolt
Knob, Washer and Bolt