Installation Guide

Liquid Combustion Technology, LLC GenII 208cc Snow Engine Manual 5rev. 7/7/10

Before Operation

PRE-OPERATION CHECKS

For your safety, and to maximize the service life of your equipment, it is very important to take a few moments before you operate the

engine to check its condition. Be sure to take care of any problem you nd, or have your servicing dealer correct it, before you operate

the engine.

Improperly maintaining this engine or failing to correct a problem before operation, could cause a

malfunction in which you could be seriously injured.

Always perform a pre-operation inspection before each operation and correct any problem.

Before beginning your pre-operation checks, be sure the engine is level and the engine switch is in the STOP position.

Check the General Condition of the Engine

• Remove any excess dirt or debris, especially around the heat shield, recoil starter, and cylinder head ns.

• Inspect for signs of damage and oil leakage.

• Be sure all shields and covers are in place. All nuts, bolts, and screws must be tight.

Check the Engine

• Check the engine oil level. Running the engine with a low oil level or improper oil can cause engine damage. To avoid the

inconvenience of an unexpected shutdown, always check the engine oil on a level surface before startup. Engine may be shipped

with or without oil. 5W-30 oil is recommended for general use. Synthetic oil is an acceptable alternative (refer to Engine Oil Level

Check in contents for proper engine oil levels).

• Check the fuel level before start-up. Since the engine must be cool before refueling, starting with a full tank will help to eliminate or

reduce operating interruptions for refueling.

Electric Start

• Determine what type of power source outlet you will be connecting the power cord to. If the starter is equipped with a 120V AC

electrical requirement, make sure to use the appropriate 120V AC household current input. For European 230V AC applications,

use the appropriate grounded extension lead and power source.

• Determine if your power source has a Ground Fault Interrupt (GFI) three-wire system by consulting with a licensed electrician.

If your power source does not have a GFI three-way ground system, DO NOT USE THE ELECTRIC STARTER due to a possible

hazardous condition.

Check all Equipment Powered by this Engine

Review the instructions provided with the equipment powered by this engine for all precautions and procedures that should be

followed before starting the engine.

SAFE OPERATING PRECAUTIONS

Review the instructions provided with the equipment powered by this engine for any safety precautions that should be observed in

conjunction with starting, shutting down, or operating the engine.

This engine is designed for COLD WEATHER USE ONLY.

Carbon monoxide gas is toxic. Breathing it can cause unconsciousness and/or death. Avoid any areas or

actions that expose you to carbon monoxide.

DO NOT place the hands on or near the exhaust system while starting.

WARNING