Instructions / Assembly

12
ASSEMBLY INSTRUCTION
The following section describes steps necessary to prepare the chipper shredder for use. If after
reading this section, you are unsure about how to perform any of the steps please call [phone]
Mon-Fri 9-5 EST for customer service. Failure to perform these steps properly can damage the
chipper shredder or shorten its lifespan.
1. Slide a Wheel (17) and Flat Washer (19) onto each end
of the Axle Assembly (16) at the lower rear of the unit.
Insert a Cotter Pin (18) through each end of the axle
and bend the Cotter Pin over to secure the Wheels in
place.
Secure the Support Leg (46) to the Engine using Bolts
(45) , Shock Absorbers (53), Large Flat Washers (54).
(See fig.3).
2. Position the chipper chute over the three threaded studs
protruding from the engine plate, and attach using
three flat washer and lock nuts M8 (15/33).
Rotate cone and cone base away from engine so cone
does not contact engine.
Tighten the flat washer and lock nuts M8 (15/33)
securely(See fig.4) .
3. Install the hopper (4) to the hopper gasket(57) with lock nut
M6(5) and flat washer(12) in the direction shown in the
figure.
Install the locking bar (27) to the hopper gasket(57) with bolt
M6×16 (6) in the direction shown in the figure (See fig.5).
Fig.3
Fig.4
Fig.5