Instructions / Assembly

5. Preheat the engine and push back the choke lever to the "RUN"

Position (See fig.16).

6. Move the throttle lever to proper position to make the gasoline

engine run at required velocity (See fig.17).

Note: Moving the Choke Lever too fast could stall the engine.

IMPORTANT: Allow the engine to run at no load for five minutes

after each start-up so that the engine can stabilize.

CHIPPING AND SHREDDING

WARNING:

TO PREVENT SERIOUS INJURY: Do not force the Chipper/Shredder. Branches cannot

be thicker than 1/2" for Hopper and branches cannot be thicker than 3" for Chipper Chute.

Do not force branches into machine. The Chipper/Shredder is designed to draw material at the proper

rate.

Never use your hands to feed material directly into the Shredder.If needed, use a stick to push the

material into the Shredder.

1. Without putting your hands into Shredder (on top), slowly

drop material into the Hopper (one branch at a time). The

machine will pull the material in automatically.

2. The Chipper Chute is located on the side of the unit; only feed

one branch in at a time, larger end first.

3. Material discharges from the discharge port at high speed.

Make sure the Discharge Bag is properly attached before use.

Do not operate the Chipper/Shredder without the Discharge

Bag in place.

4. Do not allow Discharge Bag to overfill with processed

material. This may prevent proper discharge and can result in

kickback of material. Empty bag periodically as needed.

Note: Should Chipper/Shredder jam during use, immediately turn off the Engine. Wait until the

machine completely stops. Disconnect the Spark Plug. Clear the jam in the machine by shifting the

material with a long stick. Then, resume operation.

Fig.16

Fig.17

Fig.18