Use and Care Manual

Selecting Actuation Mode

The selectable trigger can be set to either Single Sequential Actuation

mode or Contact Actuation mode.

1. Push in and hold the Actuation Selector.

2. Rotate the Selector to Single Sequential Actuation (T) or Contact

Actuation (TT).

3. Release the Actuation Selector.

NOTE: Be sure the selector is snapped into position. Understand the

actuation process before use

Air supply

1. Use clean, Dry and regulated compressed air at 70-110 PSI (4.8-7.5bar).

2. Never exceed maximum and minimum pressure. Too low or too high pressure would cause noise

wear and tear or misfiring.

3. When connecting air supply always keep hands and body away from discharge area of tool.

4. A filter- regulator-lubrication is required and should be located as close to tool as possible.

5. Keep air filter clean. A dirty filter will reduce the air pressure to the tool causing a reduction in power

and efficiency.

6. For better performance, install a quick connector in your tool and quick coupler on the hose if

possible.

7. Be sure all connections in air supply system are sealed to prevent air loss.

Typical filter/ lubricator/regulator installation order.

WARNING: Exceeding the maximum permissible operating pressure may cause the nailer to

explode, blowing metal fragments in all directions. To protect yourself from serious personal

injury, DO NOT allow your air compressor to exceed the recommended pressure when

connected to this nailer!