Use and Care Manual

• When using the sequential trip trigger, do not actuate the tool unless the tool is placed

firmly against the workpiece.

Do not drive nails blindly into walls, U floors or other work areas. Fasteners driven into live

electrical wires, plumbing, or other types of obstructions can result in injury.

Stay alert, watch what you are doing and use common sense when operating a power tool. Do not

use tool while tired or under the influence of drugs, alcohol, or medication. A moment of inattention

while operating power tools may result in serious personal injury.

DEPTH ADJUSTMENT: To reduce risk of serious injury from accidental actuation when

attempting to adjust depth, ALWAYS:

• Disconnect air supply.

• Avoid contact with trigger during adjustments.

WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other

construction activities contains chemicals known to the State of California to cause cancer,

birth defects or other reproductive harm. Some examples of these chemicals are:

• Lead from lead-based paints,

• Crystalline silica from bricks and cement and other masonry products, and

• Arsenic and chromium from chemically-treated lumber.

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your

exposure to these chemicals: work in a well-ventilated area, and work with approved safety equipment,

such as those dust masks that are specially designed to filter out microscopic particles.

WARNING: ALWAYS USE SAFETY GLASSES. Everyday eyeglasses are NOT safety

glasses. Also use face or dust mask if operation is dusty. ALWAYS WEAR CERTIFIED

SAFETY EQUIPMENT:

• ANSI Z87.1 eye protection (CAN/CSA/Z94.3),

• ANSI S12.6 (S3.19) hearing protection,

• NIOSH/OSHA/MSHA respiratory protection.