Instructions / Assembly

5
• Do not put hands near or under moving parts.
• Do not attach the hose or tool to your body. Attach the hose to the structure to reduce the risk of loss
of balance if the hose shifts.
• Wash hands after handling. This product or its power cord may contain chemicals known to the State
of California to cause cancer and birth defects or other reproductive harm.
• Never leave the operating tool unattached. Disconnect air hose when the tool is not in use.
• For overhead work, wear a safety helmet.
TOOL USE AND CARE
• Know this tool. Read manual carefully, learn its applications and limitations, as well as the specific
potential hazards related to this tool.
• Only use impact-grade sockets with air impact tools. Always use attachments rated for the speed of
the tool. Do not modify tools or attachments.
• Never use oxygen, carbon dioxide or other bottled gasses as a power source for air tools. Only use
clean, dry air at the specified pressure.
• Only use accessories for the specific tool model as identified by the manufacturer.
• Check for misalignment or binding of moving parts, breakage of parts, and any other condition that
may affect the tool's operation. If damaged, have the tool serviced before using. Many accidents are
caused by poorly maintained tools.
• Maintain tools with care. Keep tool clean. A properly maintained tool, reduces the risk of binding and
is easier to control.
• Store tools out of the reach of children and other untrained people. This tool is dangerous in the hands
of untrained users.
• Do not use the tool for anything other than its intended use.
• Do not use tool if trigger does not actuate properly. Any tool that cannot be controlled with the trigger
is dangerous and must be repaired.
• Do not force tool. Use the correct tool for your application. The correct tool will do the job better and
safer at the rate for which it is designed.
• Use clamps or another practical way to secure and support the workpiece to a stable platform.
Holding a tool by hand or against the body is unstable and may lead to loss of control.
• Keep the tool and its handle dry, clean and free from oil and grease. Always use a clean cloth when
cleaning. Never use brake fluids, gasoline, petroleum-based products, or any strong solvents to clean
your tool.
• Do not use the tool as a hammer.
• Never use gasoline or other flammable liquids to clean the tool. Never use the tool in the presence of
flammable liquids or gases. Vapors could ignite by a spark and cause an explosion which will result
in death or serious personal injury.
• Do not remove, tamper with, or otherwise cause the trigger lock or trigger to become inoperable. Do
not operate any tool which has been modified in a like fashion. Death or serious personal injury could
result.
• Do not touch the trigger unless working. Never attach air hose to tool or carry tool while touching the
trigger. The unconventional driving which will result in death or serious personal injury.
• Always fit tool with a fitting or hose coupling on or near the tool in such a manner that all
compressed air in the tool is discharged at the time the fitting or hose coupling is disconnected. Do
not use a check valve or any other fitting which allows air to remain in the tool. Death or serious
personal injury could occur.
• Never carry the tool by the air hose or pull the hose to move the tool or a compressor. Keep hoses
away from heat, oil and sharp edges. Replace any hose that is damaged, weak or worn. Personal
injury or tool damage could occur.