Installation Guide

13
***Assembling
Drive & Auger Cables over the top of the Frame
Handle will cause unnecessary tension in the cables, resulting in the Snow
blower propelling forward when starting the engine and may cause damage to the
drive & auger control
(levers) when trying to engage them.
4.
Cut and remove all tie wraps that are on Cables, Frame Handles, Drive Control (Lever) &
Auger Control (Lever).
5. Verify that the connection for the Upper & Lower Drive/Auger Cables is accurate. (See
Figure 1)
Step 2: Installing Speed Control Connection Rod
1. Install the connection rod to the hole in the Frame as indicated on Figure 2 -1.
2. Install another side of connection rod to the hole in the trigger as indicated on Figure 2-2.
Fig.2-2
Fig.2-1
Figure 2