Model No. 71392 Owner’s Manual Trim Router Table QUESTION... 1•847•780•6120 Visit us on the web at powertecproducts.com You will need this manual for safety instructions, operating procedures, and warranty. Put it and the original sales invoice in a safe, dry place for future reference.
TABLE OF CONTENTS SECTION SAFETY RULES PRODUCT SPECIFICATIONS PAGE 1 Dimensions Table Top.................................................. 11-1/2"x 15-1/2" x 3/4" ASSEMBLY 2 Unpacking Assemble Fence, Dust Port and Table Assembly the Trim Router Base Installing Router in Table MAINTENANCE 4 General Maintenance WARRANTY 5 Bit Guard.............................................................................3" x 5" Fence..................................................
WARNING For your own safety, read all of the rules and precautions before operating tool. WARNING Always follow proper operating procedures as defined in this manual even if you are familiar with use of this trim router table or any tool used with this trim router table. Remember that being careless for even a fraction of a second can result in severe personal injury.
ASSEMBLY ASSEMBLY 2 UNPACKING ASSEMBLE FENCE, DUST PORT AND TABLE Refer to Figure 1 Refer to Figure 2–6 Check for shipping damage. Check immediately whether all parts and accessories are included. 1. From the underside of the fence, insert the two T-Bolts up and through the holes on each end the fence. Place a 5/16" washer on each T-Bolt and then thread on the fence lock knobs. Do not tighten the knobs. 2.
ASSEMBLY THE TRIM ROUTER BASE Fence WARNING Fence Lock Knob T-Bolt Head Fence Adjustment Slot Round Access Hole To reduce the risk of injury, turn router off and disconnect it from power source before installing and removing accessories. An accidental start-up can cause injury. NOTE: This clear router plate provides better visibility and when used with a PORTER-CABLE style guide bushing (sold separately) it allows a bit to follow the path intended by a template or jig.
ASSEMBLY INSTALLING ROUTER IN TABLE 1. Loosen the fence locking knobs and slide the fence back on the tabletop to access the opening in the tabletop. 2. From the top of the table, lower the router with trim router base into the opening, align the three stopped holes on the underside of the router base with the three leveling screws. Figure 8 4 3. Attach the bit guard to the front of the fence using the bit guard knobs.
WARRANTY WARRANTY 5 Thank you for investing in a POWERTEC power tool. This product has been designed and manufactured to meet high quality standards and is guaranteed for domestic use against defects in workmanship or material for a period of 12 months from the date of purchase. This guarantee does not affect your statutory rights. SOUTHERN TECHNOLOGIES LLC.
Southern Technologies, LLC Waukegan, IL 60087
