Model No. AF4000 Owner’s Manual AIR FILTRATION SYSTEM QUESTION... 1•877•393•7121 Visit us on the web at www.southerntechllc.com You will need this manual for safety instructions, operating procedures, and warranty. Put it and the original sales invoice in a safe, dry place for future reference.
TABLE OF CONTENTS SECTION PAGE SAFETY RULES 1 PRODUCTION SPECIFICATIONS Horsepower (Maxmum Developed). . . . . . . . . . . . . . 1/6 HP Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 120 V ASSEMBLY 1 Unpacking Install the Unit Power Source Grounding Instructions Extension Cords Electrical Connections Hertz. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60 Hz Controls. . . . . . . . . . . . . . . . . . . .
SAFETY RULES Be aware of general power tool safety. Make sure all the safety rules are understood. • Disconnect the machine from power source whenever adjusting or replacing any parts. • Do not plug planer in unless switch is in the “OFF” position. • Keep hands away from all moving parts. • Wear eye protection or face shield during operation. • Make sure all mobile parts move freely and are free from interference. • If ceiling mounted, bottom of air filtration system must be at least 7 feet above the floor.
ASSEMBLY • If you notice any transport damage while unpacking, 2notify the supplier immediately, Figure 2 • Dispose of the packing in an environmentally friendly manner. You should take into consideration how and where you will place the unit: • It can be placed on a bench or be hung from the ceiling. 2 • This unit will work best if it is located away from corners, and heating/cooling vents. • If using on sawhorses the air filtration unit should be clamped in place.
Do not permit fingers to touch the terminals of plug when installing or removing from outlet. WARNING Do not connect to the power source until the machine is completely assembled. The machine is wired for 120 volts, 60 HZ alternating current. Before connecting the machine to the power source, make sure the switch is in the “OFF” position. Running the unit on voltages which are not within range may cause overheating and motor burn-out.
OPERATION 4 WARNING Figure 7 REMOTE CONTROL Refer to Figure 7 TIME button controls the three different timer settings. (Figure 7) • 1H will light up on the back of the unit by pressing the time button once. The machine will operate for 1 hour then turn off. • 2H will light up on the back of the unit by pressing the time button twice. The machine will operate for 2 hours then turn off. • 4H will light up on the back of the unit by pressing the time button three times.
TROUBLESHOOTING 5 SYMPTOM POSSIBLE CAUSE(S) CORRECTIVE ACTION Motor does not run. 1. Machine not plugged in 2. Power switch in "OFF" position 3. Power switch or cord is faulty 4. Fuse or circuit breaker are open. 5. Remote control is not working. 6. Remote control batteries are dead 7. lnfared receiver is not working 8. Control panel ON/OFF button is B. Inspect or replace control panel circuit board not working. 9. Control panel fuse is blown 10. Motor does not work 1.
53 5 6 As01 4 Label 66 52 61 7 60 62 54 73 (51) (2) (13) 8 59 A2 wire (2) 3 2 1 9 10 11 12 (1) (2) (3) (13) 56 57 55 58 AS02 36 40 41 42 13 14 72 39 43 44 37 38 69 15 65 45 74 (1 9) (2 0) (2 1) 22 23 18 19 20 21 16 17 64 63 (2 3) 46 ( 21) 48 49 50 Label 67 Label 68 51 ( 24) A1 wire A2 wire 47 A1 wire 24 25 71 28 (13) 26 32 31 33 30 27 34 29 35 6 AIR FILTRATION SYSTEM PARTS ILLUSTRATION Figure 10
AIR FILTRATION SYSTEM PARTS LIST Key No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 Part No.
8 WARRANTY Thank you for investing in a POWERTEC power tool. These products have been made to demanding, high-quality standards and are guaranteed for domestic use against manufacturing faults for a period of 12 months from the date of purchase. This guarantee does not affect your statutory rights. In case of any malfunction of your tool (failure, missing part, etc.), please contact one of our service technician at our service line at 1-877-393-7121 from 9 AM to 5 PM, Monday to Friday, Central time.
WARRANTY ADDITIONAL LIMITATIONS To the extent permitted by applicable law, all implied warranties, including warranties of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE, are disclaimed. Any implied warranties, including warranties of merchantability or fitness for a particular purpose, that cannot be disclaimed under state law are limited to one year from the date of purchase. Southern Technologies LLC. is not responsible for direct, indirect, incidental or consequential damages.
Southern Technologies, LLC 206 Terrace Drive Mundelein, Illinois 60060
