Use and Care Manual

UNPACKING
Refer to Figure 1.
Check for shipping damage. Check immediately whether all
parts and accessories are included. If anything is missing or
broken, contact your retailer or call 847-780-6120.
• Carefully remove all contents from shipping carton. The
shipping carton contains:
ITEM DESCRIPTION QUANTITY
A Flexible Hose 5" 1
B Collector Support Frame 1
C Main Frame Housing 1
D Base Plate 2
E Upper Bag Support Rod 1
F Collector Frame Support Rod 2
G Inlet Connector, Dual 1
H Filler Bag (Logo) 1
I Collection Bag (Plastic) 1
J Hose Clamp, 5" 2
K Bag Clamps 2
L Outlet Gasket 1
M Outlet Flange 1
ASSEMBLY
2
2
2
SAFETY RULES
SPECIFIC SAFETY INSTRUCTIONS
2
WARNING
Read and understand the instruction manual before
operating the dust collector. Basic precautions listed
below should always be followed when using your dust
collector to reduce the risk of injury, electrical shock
or fire.
• This dust collector is designed to collect sawdust only.
• Never attempt to use this dust collector to collect water
or any other liquids.
• Never try to use this dust collector to collect large
wood pieces.
• Never attempt to use this dust collector to collect metal
materials such as screws, nails or other metal parts.
• Never attempt to use this dust collector to collect
flammable or combustible dust/gas. DO NOT use near
any flammable or combustible liquids.
• Never attempt to use this dust collector to collect
anything that is burning or smoking.
• DO NOT use outdoors or on wet surfaces.
• Turn machine off, disconnect power cord and ensure all
moving parts have stopped completely before servicing
or changing/emptying the bags.
• Always wear approved eye protection and respirator
when emptying collection/filter bags.
• Ensure the machine is turned off before unplugging the
dust collector.
• Unplug dust collector when not in use.
• Grasp the plug not the cord to unplug the dust collector.
• Never pull the dust collector by the power cord.
• Keep vacuum hoses and electrical cord out of
traffic areas.
• ALWAYS ensure collection/filter bags are secured
in place.
• Do not place your hand or tools near the open inlet
while operating. Serious personal injury or damage to
the machine can happen.
• Always connect dust collector to the matched
power source.
• Place unit on stable, level surface.
• Never operate the dust collector with all blast
gates closed.
IMPORTANT : Always consider safety first as it applies
to your individual working conditions, the environment in
every shop is different.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE
Parts Bag Containing
N Hex Head Bolt 5/16-18" x 1/2"
36
O Pan Flange Head Screw
3 / 16"- 24 x 3 / 8" 1
P Open End Wrench 10-12 mm 1
Q Hex Wrench 5 mm (to be used
to remove/replace impeller only)
2
R Casters 4
S Foam Strip 1
Owner's Manual (not shown)
A
B
E
F
H
I
P
G
D
J
R
C
M
L
K
Figure 1
N
O
Q
S
ASSEMBLY