Use and Care Manual

3
ASSEMBLY
INSTALLATION
Refer to Figures 2 - 12
CAUTION
Do not attempt assembly if parts are missing. Call the
Customer service line to obtain replacement parts.
WARNING
Do not operate dust collector until completely assembled.
Do not operate this tool until you have completely read
and understood this manual.
NOTE: After unit is assembled dispose of all packaging
material in an environmentally safe way.
Tools required for assembly:
• 10-12 mm Open End Wrench
• Flat Head Screwdriver
WARNING
Ensure the dust collector is unplugged before assembling.
1. Turn the base plate upside down as shown and attach
the four casters using 16 hex head bolts. Tighten with
12 mm wrench.
Figure 2
Base Plate
Hex
Head
Bolt
Caster
2. Turn the base plate right side up and locate the four
threaded holes for the main frame housing.
Figure 3
Threaded holes
for Main Frame
Housing
Threaded holes for
Collector Support Rods
3. Align the main frame housing with the four threaded
holes in the base plate, use four hex head bolts to
secure and tighten with 12 mm wrench.
Figure 4
Main Frame Housing
Hex
Head
Bolts
Hex
Head
Bolts
4. Place the two collector supports rods on the base
plate as shown and use four hex head bolts to secure,
tighten with 12 mm wrench.
NOTE: Make sure the rods are assembled with the
bend out.
Figure 5
Main Frame
Housing
Hex Head Bolts
Collector
Supports Rod
(Back)
Bend Out
Collector
Supports Rod
(Front)
5. Orient the inlet flange of the collector support frame
to face the main housing outlet funnel, attach the
collector frame support rod on the front of the machine
to the collector support frame. Use two hex head bolts
to secure, tighten with 12 mm wrench.
Figure 6
Inlet Flange
Facing Main
Frame Housing
Hex Head Bolts
Collection
Support Frame
Collector Support
Rod (Front)
6. Hold the back of the collection support frame and slide
the upper support rod between the collector support
rod and collector support rod (back). Secure with two
hex head bolts, tighten bolts with 12 mm wrench.
Figure 7
Hex Head
Bolts
Collection
Support
Frame
Collector Support Rod (Back)
Upper Support Rod
7. Place the gasket onto the top of the opening in the
main frame housing.
8. Place the adapter on top of the gasket and use
eight hex head bolts to secure. Tighten bolts with
12 mm wrench.