Use and Care Manual

OPERATION
5
OPERATION
5
WARNING
Do not use the table saw stand for scaffolding or as a
ladder. Make sure to securely tighten all fasteners before
using. Maximum capacity is 331 lbs (150 kg).
Folding and Unfolding the Stand
Refer to Figure 12
NOTE: Take care when folding and unfolding the stand to
reduce the hazard of pinching hands and fingers.
To Fold
• While holding the handle, pull the lever and lift up on
the handle, the table top will tilt down and the frame will
fold close.
To Unfold
• While holding the handle, pull the lever and push down
on the handle until it clicks into place.
Figure 12
Transportation and Storage
Refer to Figure 13, 14
WARNING
Risk of unsafe operation. Ensure proper footing and use
caution when rolling the table saw stand to prevent tipping
or loss of balance.
• See the Folding and Unfolding the Stand paragraph
to place the stand in the folded position.
• To move the stand, use handle to lift and tilt the table
saw stand onto the wheels. Move table saw stand
as shown.
• Holding the handle, carefully lower the stand to
the ground.
• The stand may be stored in the vertical or
horizontal position with the tool attached.
Figure 13
Figure 14