Operation Manual

MOUNTING THE CONTROL BOX

Once all connections are made to the start/stop switch and the hour meter, fasten the

control box to the desired location with the screws provided.

INSTALLING THE POWER OUTLET BOX

SELECT LOCATION

Determine the location for the AC power outlet box. It should be mounted where the

driver has easy access to the outlets. Consideration should be taken as to the devices the

driver will need AC power for such as, Television, microwave, refrigerator etc.

Suggestion, mount the outlet box where most of the appliances a driver may use will be

within reach of the outlets without the use of extension chords.

MOUNTING THE POWER OUTLET BOX

Secure the power outlet box to desired location with the screws provided.

ROUTING WIRES

Once location has been chosen for the power outlet box, route the wires back to the

terminal block making sure the wires are secured with wire ties or clamps. These wires

should be ran in a way that they will not interfere with anything under the bunk and clear

of anything abrasive.

CONNECTIONS

Once wires are secured connections for the AC power can be made. Cut the outlet box

cord to the desired length. Carefully remove approximately 2” to 2 ½” of the outer jacket

from the cord. Separate the 3 wires and crimp the appropriate terminal connector to each

wire. Connect the black positive (+) wire to the black wire on the terminal block. Connect

the white wire to the white wire on the terminal block and the green wire to the ground

(green) wire on the terminal block.