Operation Manual

3) If a fault occurs during the operation of the PT-3000, correct the problem and then
reset the PT ECU-64. To do this the main power switch for the APU (located on
the internal control panel on the APU) must be turned OFF then back ON. This
will clear the fault code.
IMPORTANT: Make sure driver control panel switch is in the OFF position before
attempting to clear fault codes. If driver control panel switch is in ON position when
resetting the ECU, the unit will start and possibly cause injury.
Stopping the Engine
It is recommended to disconnect or reduce the power load by turning off
appliances before shutting down the engine. Push the drivers control switch to the STOP
position, the engine will stop.
Powering Appliances and Auxiliary Systems
Once the PT-3000 is running, you will have AC power through the power outlet
box. Plug devices such as television, DVD player, cell phone charger etc. directly into
outlet.
For heating and air conditioning system please refer to the user’s guide supplied
with the heating and air conditioning system.
IMPORTANT: Damage to starter motor, starter solenoid, run solenoid or any generator
component due to excessive or prolonged starting attempts, or attributed to an external
low battery control monitoring or auto start system not approved by Power Technology
SE Inc. will not be covered by the Power Technology SE inc. limited warranty.
21