Operation Manual

REQUIREMENTS FOR INSTALLATION

PARTS LIST

1 - PT-3000 Unit

1 - Battery Charger

1 - Terminal block

1 - Terminal block cover

2 - Frame Mounting Angle Brackets (L&R)

8 - ½” x 2 Mounting Bolts, Nuts and Washers

6 - 5/8” x 2 ½” Mounting Bolts, Nuts and Washers

1 - Fuel pickup tube

1 - Cab mounted Start/Stop panel

1 - 1 ¼ rubber grommet

4 - #4 hose clamps

2 - Battery cable ends

2 - Heat shrinks (for battery cable ends)

10 - Sheet metal screws

20 - Wire ties

TOOLS REQUIRED

Typical mechanics tools

Drill

1 ¼” Hole saw

Tape measure

Utility knife

Tubing cutter

½” NPT Tap (for fuel pickup tube)

3/4” Drill bit or tapered drill bit (for ½” NPT tap)

Heavy grease (to keep metal shavings out of fuel tank)

Liquid thread sealant

Transmission jack, forklift or overhead hoist