User Manual

2. Installationandoperation

Inspection

RemovetheUPSfromitspackagingandinspectitfordamagethatmayhaveoccurredduring
shipping.Ifanydamageisdiscovered,repacktheunitandreturnittotheplaceofpurchase.


Charging

Thisunitisshippedfromthefactorywithitsinternalbatteryfullycharged,however,some
chargemaybelostduringshippingandthebatteryshouldberechargedpriortouse.Plug
the unit into an appropriatepowersupply andallowthe UPS tochargefully by leaving it
plugged in for
 at least 10 hours with no load (no electrical devices such as computers,
monitors,etc.)connected.


Placement

InstalltheUPSunitinanyprotectedenvironmentthatprovidesadequateairflowaroundthe
unit,andisfreefromexcessivedust,corrosivefumesandconductivecontaminants.Donot
operateyourUPSinanenvironmentwheretheambienttemperatureorhumidityishigh.

