Owner manual

3.8 Turn off the UPS with mains (AC source)

1) Firstly turn off the UPS (inverter) to bypass mode, please press the

button continuously for more than 2 seconds.

2) After you press the button, the buzzer will beep once. All the LEDs

will be lightened, and then black out one by one. Then the panel will

display the bypass mode.

Note 1: If the UPS have been set to enable the bypass output, the

output socket will have voltage from mains directly after you turn off

the UPS (inverter) to bypass mode.

Note 2: Because there is risk of power loss for the loads if you turn

off the UPS to bypass mode, please make sure the loads are

prepared for your operation.

3) If you want to turn off the output of UPS and shut down the UPS

completely, you have to cut off the mains input of UPS.

Note: please make sure all the loads are prepared or turned off for

your operation before you shutdown the UPS system.

4) After you cut off the mains input of UPS to shut down, all the LEDs

will be lightened, and then black out one by one. Finally all the LEDs

will be lightened to indicate the UPS is saving data to the memory.

After the saving process, the UPS will be shutdown completely.

3.9 Turn off the UPS with battery (DC) only