Owner manual

ManualsBrandsPowerWalker ManualsEquipmentVI 400 IEC

POWER WALKER VI 400/600/800

Uninterruptible Power Supply

USER’S MANUAL

PROBLEM POSSIBLE CAUSE SOLUTION

1. The power switch is in

“OFF” or not pressed

1. Press power switch to turn on.

2. The voltage for battery is

weak

2. Re-charge the UPS at least 8

hours.

3. Battery failure 3. Replace with the same type of

battery or call for service.

NO LIGHT (UPS

NOT ON)

4. Power Connection looses 4. Check the input power and

replug it again

BUZZER BEEPS

CONTINUOUSLY

1. Overload of the UPS. 1. Remove the noncritical load or

call for service.

1. Battery failure

1. Replace with same type of

battery or call for service.

2. AC fuse may be burnout. 2. Replace fuse or call for service.

3. Battery is not fully

charged.

3. Re-charge the UPS at least 8

hours.

BACKUP TIME IS

SHORT OR

ALWAYS IN

“BATTERY MODE”

4. Power Connection loses

4. Check the input power and

replug it again

7. TROUBLE SHOOTING

To call for service, please have the model, serial number, and

description of the problem available.

Summary of content (6 pages)

PAGE 1
7. TROUBLE SHOOTING To call for service, please have the model, serial number, and description of the problem available. PROBLEM NO LIGHT (UPS NOT ON) POSSIBLE CAUSE SOLUTION 1. The power switch is in 1. Press power switch to turn on. “OFF” or not pressed 2. The voltage for battery is 2. Re-charge the UPS at least 8 weak hours. 3. Battery failure 3. Replace with the same type of battery or call for service. 4. Power Connection looses 4.
PAGE 2
Thank you for purchasing PowerWalker UPS. Safety information and operating instructions are included in this manual. To ensure the correct use of the UPS, please read this manual thoroughly before operate it. And save this manual properly. 1. INTRODUCTION PowerWalker VI series is a line interactive UPS which is designed to protect your personal computer or sensitive electronic equipments. The UPS is equipped with boost to stabilize input voltage.
PAGE 3
2. SAFETY REQUIREMENTS . Please save this manual properly. This manual includes important safety information. Please read it carefully and thoroughly before operating the UPS. Comply with all the warnings and operating instructions on the unit and in the manual strictly. To reduce the risk of electric shock, the user must disconnect the UPS from the mains supply before installing any cable. To reduce the risk of electric shock. Do not attempt to disassemble the UPS.
PAGE 4
Back Panel 5. RS-232 Communication Port This communication port is used to communicate with a computer or modem and support the operating systems 2 IEC 1. Battery Power Supplied Receptacle The power supplied receptacles are used for battery to power up your equipments while AC is failure. 2. AC Input Power Receptacle The power receptacle is used to plug in the power cord that provides power to the UPS 3.
PAGE 5
4. INSTALLATION Before the installation, please ensure the power switch on the UPS is in "OFF" position, and the voltage of the AC utility source corresponds to the identification label on the rear panel. 1. Inspection Inspect the UPS upon the receipt. If there is any damage, please report it to dealer immediately. The packaging is used recyclable material, please save it for reuse or dispose of it properly. 2.
PAGE 6
5. MONITORING SOFTWARE After the UPS has been installed, you must install the software(Smart Power) that came packaged with your UPS. Smart Power monitoring software performs the monitoring and controlling functions. This software displays the status and diagnostic symptoms on the monitor. In case of the power failure, it provides the auto shutdown for the computer. If you download the software from Internet, please key the serial number: 726T25-4791-2N39546. 6.