User's Guide Power Supply 5115

13
Powerware
®
5115 User’s Guide www.powerware.com
CHAPTER 4
ADDITIONAL UPS FEATURES
This section describes:
Changing the voltage configuration
Using the communication port
The Network Transient Protector
Voltage Configuration
The DIP switches on the rear panel of each unit (see Figure 12) are used
to configure the output voltage and input voltage range.
1. The UPS must be completely shutdown.
Turn the UPS off by pressing the
buttononthefrontpanel
and then unplug the UPS.
2. Set the DIP switches according to the configurations in Table 1.
3. Plug the UPS into a power outlet and press the
button to
turn the UPS on.
UPS Rear Panel
ON
OFF
21
Figure 12.DIP Switches