User's Guide Power Supply 9170

Installation Setup

Powerware

9170 User's Guide  LTM-1344 B Uncontrolled Copy

Location Requirements

Install the Powerware 9170 UPS as close as possible to the equipment or

the load distribution panel it will protect. If this distance is more than

25 ft (7.6m), transient noise can reappear in the electrical distribution

system.

If additional Powerware 9170 system batteries are in a separate cabinet,

the external battery cabinet should be located as close as possible to the

Powerware 9170 UPS. If the batteries will be further from the unit than

the standard cables allow, contact your service representative or your

local distributor for assistance.

UPS Unpacking and Setup

The Powerware 9170 UPS is shipped in a carton on a shipping pallet.

Power and battery modules are shipped in separate boxes on another

pallet. Three-slot cabinets and modules are shipped on one pallet.

NOTE Verify that all Powerware 9170 UPS power modules are the proper type for the

UPS cabinet: Universal (single-phase) modules have white labels; split-phase modules

have blue labels. Do not mix blue and white modules in the same UPS cabinet.

To open the UPS carton and remove the UPS from its shipping pallet,

use one of the following procedures. Also refer to the unpacking

instruction sheet (LTS-1724) packed inside the UPS shipping carton.

Three- and Six-Slot Cabinets

1. Open the top of the carton by cutting the banding straps that

hold the carton to the pallet. Open the carton flaps or lift the

cover off.

2. Remove any packing material inside the carton. Also remove

the cartons from the cabinet module slots containing front

panel bezels, electrical or mechanical hardware, and printed

material.

3. Two people are required to lift the cabinet; one to lift the two

front straps and one to lift the two rear straps.

NOTE Do not attempt to lift the cabinet by the module shelves or other convenient

edges or panels.